tipster.website.

Escort Zx2 Repair Manual







Start the veto with the vain on the ground. The android must not be vain. The newer Belly Veto has vain holes compared to the vain oval ones as seen tin the picture below. Desperate, I pulled the door sport off and played with the wires a bit.

This TSB Escort zx2 repair manual is being republished to assist in diagnosing idle vibration. Remove battery and battery tray. Refer to the appropriate model year Workshop Manual, Section Remove the rear lower cross-member attached with four 4 bolts Fig. Remove the engine support cross-member that runs from front to rear of the engine Belly Band. This can be accomplished by removing the front two 2 attaching bolts, the rear two 2 attaching nuts and the four 4 Engine Mount 1 and 2 nuts Fig. Use a Drill Bit Fig. Loosen the center bolt on the 1 rear lower Engine Mount Fig. Loosen the center bolt on the 2 front lower Engine Mount Fig.

Remove original front and rear engine support cross-member bushings Fig. Use a utility knife or hack saw to achieve desired shape Fig. Torque the retaining nuts and bolts to N. Reinstall the front attaching points of the Belly Band with the original two 2 bolts. Reinstall rear-attaching points of the Belly Band with original two 2 nuts Fig.

2000-2004 Ford Vehicles Workshop Repair Service Manual

Install the Engine Mount 1 and 2 retaining nuts, do not tighten at this time. Escort zx2 repair manual the 3 Engine Mount and damper Fig. Torque the retaining bolts to N. Do not paint bracket, install as received. Removal Remove power steering bracket bolt to frame. Raise engine using 3-bar support. Remove retainers for engine mount bracket and remove bracket. Installation Install bracket and install retainers. Torque to N. The late bushings also show a top and bottom view, the early looks the same, top or bottom.

The new rear bushings are exactly the same as the "new" front repsir, which are also the same as the early rear bushings already on the car. I did not know that at the time, so I also bought the rear ones from Escort zx2 repair manual salvage yard. The salvage yard rear bushings were in better condition than what I reapir on the car, so I went ahead and replaced them. Torque the retaining nuts and bolts to N. Reinstall the front attaching points of the Belly Band with the original two 2 bolts. Reinstall rear-attaching points of the Belly Band with original two 2 nuts Figure 1. Torque the retaining nuts and bolts to N-m lb-ft. Torque the retaining bolts to N. Do not paint bracket, install as received.

This is where I was glad that the 03 in the salvage yard still had its bracket, and as luck would have it, the engine was already removed and all of the hardware still present. The mount looked exactly the same to me at first. It wasn't until I got it home and took off the existing one that I noticed the difference. In the picture below, notice the slotted hole where the motor mount attaches.